<![CDATA[SoliForum - 3D Printing Community — How do I use a multimeter to adjust the trimpot?]]> https://www.soliforum.com/topic/10364/how-do-i-use-a-multimeter-to-adjust-the-trimpot/ Wed, 11 Mar 2015 16:23:41 +0000 PunBB <![CDATA[Re: How do I use a multimeter to adjust the trimpot?]]> https://www.soliforum.com/post/89266/#p89266 android78 wrote:

There are three pins on the trim pots, two on one side and one on the other. Measure the one on one side and the contact closest to the terminals for stepper motor connectors on the other.

A fast reply that tells me exactly what I was looking for, thank you very much!

]]> Wed, 11 Mar 2015 16:23:41 +0000 https://www.soliforum.com/post/89266/#p89266 <![CDATA[Re: How do I use a multimeter to adjust the trimpot?]]> https://www.soliforum.com/post/89232/#p89232 There are three pins on the trim pots, two on one side and one on the other. Measure the one on one side and the contact closest to the terminals for stepper motor connectors on the other.

]]> Wed, 11 Mar 2015 05:18:34 +0000 https://www.soliforum.com/post/89232/#p89232 <![CDATA[How do I use a multimeter to adjust the trimpot?]]> https://www.soliforum.com/post/89231/#p89231 I can't seem to figure this out from other threads.

On Solidoodle's support page (http://support.solidoodle.com/hc/en-us/ … Adjustment), it gives you the recommended voltage values, but it does not clarify where exactly to probe the motherboard.

If the voltage is too high, what should I expect from the printer's operation, versus if it is too low?

]]> Wed, 11 Mar 2015 05:15:05 +0000 https://www.soliforum.com/post/89231/#p89231