I've used Hatchbox ABS (orange) at 230 degrees.

I was using Hatchbox Black ABS at the SoliPrint 1.0 extruder default (sorry don't recall what it was) without issue.

I've also used the blue Sainsmart ABS available on Amazon.  It comes on a cardboard spool that some people consider problematic, one person referred to such spools as "janky", but I could give a rat's A so long as it prints well and is cheap.  I built a spool holder from about $2 worth of pvc so I'm good.

I initially was having problems getting a completed print and I was blaming the filament, but I think I just picked a problematic model.  It had some overhangs that were curling upwards and the print head was clipping against it as it moved back and forth... after it does that a while it impedes extrusion enough that I'll get a clog.  It took me about 6 or 7 test prints to notice that upward curling and stop blaming the material.

Dream-Cypher wrote:

.  I've also used Signswise PLA at 195 degrees with good results.

On the Press?

Yes.  See this thread: http://www.soliforum.com/topic/10055/p … t-request/

.  I've also used Signswise PLA at 195 degrees with good results.

On the Press?

What 3rd party ABS filament have you bought and had success with?
If you add temperature of extruder would be helpful too!