Very interested in your $299 printer, how long you spend to assemble and calibrate it?
How about extruder and hotend? Could you show some pictures?
How many prints you completed by this printer, all are good?
This printer is made from China, right? How about shipping charge?
For the low cost 3D printer, I just saw
Solidoodle
XYZ
Geeetech
Which one is better?

No, I am just a new guy in 3D printing, cheap is enough for me.  So how is your feeling, I mean is there any wrong when you are using?

So far , I haven't met something about the printer that worth complaining. But I have to spend some time to set the printer in Repetier. If something's wrong, that is my wrong setting. Everything of the printer works well.

wenganxiang wrote:

likered wrote:

Not bad, i think you can make a real-3D model, instead of a map.

Indeed, I think I can print a bigger one and hang it on the wall.

World map is also a good choice,ha

By the way, can you tell me where you buy your printer, did it take much time to get it?

I bought it from Geeetech's homepage, and I received it after about a week.
Here is the link:
http://www.geeetech.com/acrylic-geeetec … p-884.html

i bought this for fun, so I chose a cheaper one. If you want a better performance, I suggest ME Ducer or ME Creator.

likered wrote:

Not bad, i think you can make a real-3D model, instead of a map.

Indeed, I think I can print a bigger one and hang it on the wall.

World map is also a good choice,ha

By the way, can you tell me where you buy your printer, did it take much time to get it?

Not bad, i think you can make a real-3D model, instead of a map.

Indeed, I think I can print a bigger one and hang it on the wall.