<![CDATA[SoliForum - 3D Printing Community — Unusual Object Query]]> 2015-02-16T18:28:48Z PunBB https://www.soliforum.com/topic/9994/unusual-object-query/ <![CDATA[Re: Unusual Object Query]]> Another option would be to print the 3 walls and roof separately laid flat then stick it all together with super glue or acetone.

]]> https://www.soliforum.com/user/6872/ 2015-02-16T18:28:48Z https://www.soliforum.com/post/85589/#p85589 <![CDATA[Re: Unusual Object Query]]> khalid87 wrote:

Good Morning,

I've just purchase a DaVinci for printing 3d conservatory and sunroom models.

I have never done this before and have a quick question - will the model in the link below print ok or do you think the roof will fall when it begins to print because there is no structure underneath it?

I cannot post the image or a direct hyperlink as I am new to the forum.

s12.postimg.org/5pvdc4za5/roof.jpg

Thank you in advance for your assistance.


You would have to set your slicing software to add supports then remove/cutout the supports once the model is printed. The windows would also get support material as well. The slicing software figures out where it is needed and adds it.

]]> https://www.soliforum.com/user/7731/ 2015-02-16T18:07:41Z https://www.soliforum.com/post/85580/#p85580 <![CDATA[Unusual Object Query]]> Good Morning,

I've just purchase a DaVinci for printing 3d conservatory and sunroom models.

I have never done this before and have a quick question - will the model in the link below print ok or do you think the roof will fall when it begins to print because there is no structure underneath it?

I cannot post the image or a direct hyperlink as I am new to the forum.

s12.postimg.org/5pvdc4za5/roof.jpg

Thank you in advance for your assistance.

]]> https://www.soliforum.com/user/9641/ 2015-02-16T09:07:59Z https://www.soliforum.com/post/85514/#p85514