2015-02-11T18:33:30Z PunBB https://www.soliforum.com/topic/9885/sd2-run-joblong-pause-print/ I didn't even know there was a setting like that in Rep. Where is it located in the software menus? Ill have to double check it.
I tried going from V0.85b to a newer version a few months ago, but the SD2 wouldn't respond at all despite all my fiddling around with settings. And when I went back to 85b, this little quirk appeared.

]]> https://www.soliforum.com/user/4552/ 2015-02-11T18:33:30Z https://www.soliforum.com/post/84741/#p84741 For me it it caused by it waiting for the bed to reach temperature.   Did you have this disabled previously?

]]> https://www.soliforum.com/user/6045/ 2015-02-11T18:30:03Z https://www.soliforum.com/post/84739/#p84739 Hello folks,
Working on a SD2 with RepV0.85b
Use to be I would hit run job after slicing, extruder would move into position and immediately start printing.
Now however, I click print job, extruder moves into position, touching the print bed, retracting a few mm, then go back down to the print bed, and just stops... for around 10 or so seconds. causing the plastic to glob around the extruder.
needless to say this causes me a headache every time I initiate a print, regardless of what i'm printing. .
Any ideas?
Thanks
-Ryan

]]> https://www.soliforum.com/user/4552/ 2015-02-11T18:25:02Z https://www.soliforum.com/post/84736/#p84736