<![CDATA[SoliForum - 3D Printing Community — Noob questions]]> 2015-03-06T05:53:32Z PunBB https://www.soliforum.com/topic/9682/noob-questions/ <![CDATA[Re: Noob questions]]> The brand I use for printing is from Australia actually.

Brand: Aussie
Type: Instant Freeze
Strength: Extreme Hold

Also, I find this spray works best when applied right before printing. Not applied when cooled. That is when it is at its stickiest.

If you print without heating the bed, I get the best results with adhesion since I can literally spray this on 10 seconds before hitting Print.

It gets its best stick about half a minute to a minute in. At about 3 minutes it dries up and only serves its purpose midly when the bed is heated to 95c

]]> https://www.soliforum.com/user/9872/ 2015-03-06T05:53:32Z https://www.soliforum.com/post/88542/#p88542 <![CDATA[Re: Noob questions]]> android78 wrote:

(only a few brands in Australia seem to work, and they're the expensive ones)

Could you share which ones you've used/recommend? I'm also in Aus, and it's always hard when people say to use certain brands and you can't source them locally, so it'd be great if you could share. This is day 3 of having my Press and I'm trying to remedy the adhesion problem.

]]> https://www.soliforum.com/user/9907/ 2015-03-06T00:58:44Z https://www.soliforum.com/post/88514/#p88514 <![CDATA[Re: Noob questions]]> I just used warm water to clean the glass.  Obviously you remove it from the printer first. 
Once clean, used a liberal spray of hairspray (only a few brands in Australia seem to work, and they're the expensive ones) and then slide the glass back in.  The good thing with hair spray is that you just rinse under warm water to remove it when it gets messed up.

]]> https://www.soliforum.com/user/9350/ 2015-02-04T20:19:31Z https://www.soliforum.com/post/83193/#p83193 <![CDATA[Re: Noob questions]]> Thanks! i didn't know about the software

]]> https://www.soliforum.com/user/9059/ 2015-02-04T04:54:35Z https://www.soliforum.com/post/83134/#p83134 <![CDATA[Re: Noob questions]]> Z calibration doesn't work in Soliprint 1.1. Use Soliprint 1.0 instead.

Try some acetone on the glass bed?

]]> https://www.soliforum.com/user/9007/ 2015-02-04T04:23:35Z https://www.soliforum.com/post/83123/#p83123 <![CDATA[Noob questions]]> How can i clean the glass bed? and why  I can't run the z calibration? english is not my natal language, it says something about z sensor being pressed, anybody could explain me?

]]> https://www.soliforum.com/user/9059/ 2015-02-04T04:22:22Z https://www.soliforum.com/post/83122/#p83122