<![CDATA[SoliForum - 3D Printing Community — Solidoodle 3 Diagonal Banding]]> 2015-02-02T06:54:48Z PunBB https://www.soliforum.com/topic/9632/solidoodle-3-diagonal-banding/ <![CDATA[Re: Solidoodle 3 Diagonal Banding]]> Thanks for your help. No,  it wasn't in vase mode but after I adjusted the vref dial at the back the results were amazing! Check out the picture below to see the difference. The post-vref adjustment cube is on the right.

]]> https://www.soliforum.com/user/8354/ 2015-02-02T06:54:48Z https://www.soliforum.com/post/82845/#p82845 <![CDATA[Re: Solidoodle 3 Diagonal Banding]]> Did you print this in VASE mode?  That could be the reason you see the diagonal banding.

]]> https://www.soliforum.com/user/1357/ 2015-02-01T03:46:31Z https://www.soliforum.com/post/82670/#p82670 <![CDATA[Re: Solidoodle 3 Diagonal Banding]]> It's called moire. You can combat this in a number of ways. The easiest (and cheapest) is to adjust the E VREF on the board. Be sure to use a non-conductive screwdriver and tune by ear as you extrude.
This has been covered quite a few times, so use the search feature. If you have any further questions, feel free to ask!

]]> https://www.soliforum.com/user/4188/ 2015-02-01T03:45:55Z https://www.soliforum.com/post/82669/#p82669 <![CDATA[Solidoodle 3 Diagonal Banding]]> I've just installed my e3d v6 and new power supply and I've just done my first test print to calibrate the extrusion multiplier. Before I did this I levelled the bed,  did the PID tuning and calibrated my extruder steps per mm but I'm getting this diagonal banding on all sides of my cube.

I think that it might be a z-wobble problem but I'm not sure. Does anyone know what could be the cause of this?

]]> https://www.soliforum.com/user/8354/ 2015-02-01T03:00:44Z https://www.soliforum.com/post/82651/#p82651