<![CDATA[SoliForum - 3D Printing Community — My first great print with the Press]]>2015-01-25T18:07:13ZPunBBhttps://www.soliforum.com/topic/9495/my-first-great-print-with-the-press/<![CDATA[Re: My first great print with the Press]]>Yes, just treat each "glass" piece as a separate model, which it is, and change your filament to change color for each bird. I printed frame in brown, birds as shown. Note: If you choose honeycomb infill about 20% for "glass", you will see that pattern inside the "glass". I setup a profile in Slic3r named glass, and saved. 1 top, 1 bottom, 20% honeycomb infill. "Glass" pieces are set to print at 4 layers, 1 top 1 bottom and 2 infill layers. I usually print the "glass" pieces slower than normal to ensure good adhesion...and remember, the frame prints upright, the "glass" pieces print upside down. You are to flip the pieces over to insert into the frame. Printed in ABS.]]>https://www.soliforum.com/user/614/2015-01-25T18:07:13Zhttps://www.soliforum.com/post/81479/#p81479<![CDATA[Re: My first great print with the Press]]>http://www.thingiverse.com/thing:650483 Prints in pieces, birds are separate from frame.]]>https://www.soliforum.com/user/134/2015-01-25T17:36:34Zhttps://www.soliforum.com/post/81474/#p81474<![CDATA[Re: My first great print with the Press]]>How did you make the birds different colors?]]>https://www.soliforum.com/user/574/2015-01-25T17:25:33Zhttps://www.soliforum.com/post/81471/#p81471<![CDATA[My first great print with the Press]]>This is my first great print with the Press and I want to show it off. Its on Thingiverse, search for Skyblue if any interest in printing it.