SoliForum - 3D Printing Community — problem with stl file

Re: problem with stl file

2015-01-27T10:16:22Z

if you still need help, i can run them on some proprietory software in the company I work for. let me know

Re: problem with stl file

2015-01-26T14:15:59Z

Or the file is simply too large to upload. The server seems to allow files that are less than 5MB. ANything bigger than that it rejects.

Depending on the file, it may be possible to reduce it by zipping it. If after zipping it's still to large, then you'll have to use one of the on line storage services.

Re: problem with stl file

2015-01-26T07:55:23Z

likely just bad or corrupted download file
maybe go to site its from and check with author

Re: problem with stl file

2015-01-26T06:43:16Z

Warning! The following errors must be corrected before your message can be posted:

The selected file was too large to upload. The server didn't allow the upload.

This is the error i am receiving

Re: problem with stl file

2015-01-26T06:35:30Z

Tried putting file on here and it wouldn't let me kept getting an error message

Re: problem with stl file

2015-01-24T16:05:03Z

Re: problem with stl file

2015-01-23T23:53:50Z

It would help if you were to post the STL so we could take a look at it.

problem with stl file

2015-01-23T17:29:30Z

Having a problem with stl file. Sent thru netfabb gives me an error of mesh calculation failed calculation terminated. Thanks for any help