SoliForum - 3D Printing Community — Sleep message, then job completes without printing

Re: Sleep message, then job completes without printing

2013-02-27T19:15:32Z

I've seen the sleep message on the LCD when unplugging the hot end thermistor. Look at your temperature graphs in RH to see if they have any sharp drops and check your wiring.

Re: Sleep message, then job completes without printing

2013-02-27T15:09:56Z

I remember reading it but I have no earthly idea why it would happen. Don't take it personal

Re: Sleep message, then job completes without printing

2013-02-27T14:48:23Z

Seriously, no one going to answer this? No one else has this problem? I have had great prints, though intermittently a print stops within the first few layers, goes to sleep, then ends. Lately it heats up, goes to sleep, ends print. This is frustrating.

Searching through this forum yielded no results but my own post. There was a non-resolved post on Google groups, but they are using a mac computer with RH; I am using the panelolu sd card. Obviously my computer was not in sleep mode.
I feel like I am shunned by this community.

Sleep message, then job completes without printing

2013-01-02T12:44:11Z

Has anyone else run into the above situation? I was happily printing away, working over my New Year's day hangover, for most of the day (11am- 8p), all off of my Panelolu. After 8p, and some flying spaghetti monsters of a few failed prints, I tried to print again. But, when I selected the GCode, the printer homed, then told me it was sleeping. After it was done with its nap, it homed again, then shut off the extruder and bed temps, and killed the motors like it was completed. Was this a case of overheating, and my sanguino telling me to quit it while it rests?