<![CDATA[SoliForum - 3D Printing Community — OOPs]]> 2015-01-02T14:36:45Z PunBB https://www.soliforum.com/topic/8983/oops/ <![CDATA[Re: OOPs]]> wire10ga wrote:
wardjr wrote:
satman49 wrote:

Been there ,done that.

+1

+1 as well smile

+1...guilty as charged tongue

]]> https://www.soliforum.com/user/131/ 2015-01-02T14:36:45Z https://www.soliforum.com/post/77203/#p77203 <![CDATA[Re: OOPs]]> wardjr wrote:
satman49 wrote:

Been there ,done that.

+1

+1 as well smile

]]> https://www.soliforum.com/user/134/ 2015-01-02T14:14:12Z https://www.soliforum.com/post/77201/#p77201 <![CDATA[Re: OOPs]]> wardjr wrote:
satman49 wrote:

Been there ,done that.

+1

Guilty

]]> https://www.soliforum.com/user/4251/ 2015-01-01T23:16:14Z https://www.soliforum.com/post/77139/#p77139 <![CDATA[Re: OOPs]]> satman49 wrote:

Been there ,done that.

+1

]]> https://www.soliforum.com/user/2291/ 2015-01-01T23:01:50Z https://www.soliforum.com/post/77136/#p77136 <![CDATA[Re: OOPs]]> Been there ,done that.

]]> https://www.soliforum.com/user/574/ 2015-01-01T22:09:38Z https://www.soliforum.com/post/77130/#p77130 <![CDATA[Re: OOPs]]> Pobody's Nerfect!

]]> https://www.soliforum.com/user/3444/ 2015-01-01T21:22:21Z https://www.soliforum.com/post/77127/#p77127 <![CDATA[OOPs]]> It has been said we should learn from our mistakes. And it is even better to learn from the mistakes of others.
So in that vain I post a couple of stupid mistakes I recently made with my printer.
1) Hardware  when using a magnetic tip driver with interchangeable bits make sure the bit stays with the screwdriver after adjusting the set screws in the pulleys.  I happily adjusted a pulley attempted a test print and immediately heard a horrible sound the bit had stayed in the set screw jambed against the back wall of the printer and limited y movement to half a turn on the back rod. Duh I should know better.
2) software  it seemed the changes I made to Slic3r were not changing. Well it helps if you change the same profile that the program is using . 

OK I feel stupid and laugh if it makes you feel better.
so I hope this post either helps someone from repeating my error and or gives someone a good laugh.
Tin

]]> https://www.soliforum.com/user/6775/ 2015-01-01T21:11:45Z https://www.soliforum.com/post/77125/#p77125