SoliForum - 3D Printing Community — How to edit Firmware for e3d v6 thermistor on SD4

Re: How to edit Firmware for e3d v6 thermistor on SD4

2014-12-30T20:11:29Z

A moderator can append [Solved] to the beginning of this topic. Thanks everyone for your help! Satman's post above did the trick.

Re: How to edit Firmware for e3d v6 thermistor on SD4

2014-12-29T02:59:19Z

Yes. The SD4 uses the Printrboard
This is a Printrboard

Re: How to edit Firmware for e3d v6 thermistor on SD4

2014-12-29T02:47:41Z

No where on the board is this indicated in writing. I can say this is the SD4 from October ordered directly from Solidoodle. From the pictures I have seen on images.google.com, I would say yes, it is the PrintRBoard.

Re: How to edit Firmware for e3d v6 thermistor on SD4

2014-12-29T02:41:42Z

Does the SD4 use Printrboard?If so take a look at this http://wiki.solidoodle.com/update-firmware

How to edit Firmware for e3d v6 thermistor on SD4

2014-12-29T01:52:36Z

As the title suggests, I'm in need of instruction on how to update the firmware of the SD4 to the new thermistor.

I know the following:

Reconfigure your firmware for the Semitec 104GT2 thermistor:
In Marlin this means using thermistor definition number 5:
#define TEMP_SENSOR_0 5
In Repetier Firmware use thermistor definition number 8:
#define EXT0_TEMPSENSOR_TYPE 8

For safety it is strongly recommended configure your firmware to limit the maximum heater power:
In Marlin this means using thermistor definition number 5:
#define PID_MAX 255
In Repetier Firmware use thermistor definition number 8:
#define EXT0_PID_MAX 255

But my question isn't what contents to edit, it's HOW to edit, what/where the firmware is accessed.