<![CDATA[SoliForum - 3D Printing Community — Calibrate flow rate]]>2014-12-29T17:01:24ZPunBBhttps://www.soliforum.com/topic/8911/calibrate-flow-rate/<![CDATA[Re: Calibrate flow rate]]>It's much easier and accurate to download this: http://www.thingiverse.com/thing:271736
Then measure the wall, it should(as said) be the same as your extrusion multiplier.
]]>https://www.soliforum.com/user/2918/2014-12-29T17:01:24Zhttps://www.soliforum.com/post/76851/#p76851<![CDATA[Re: Calibrate flow rate]]>well. Used my dial calipers and found out the filament is extruding at .43 mm thick. then I printed a cbe with 2.5 mm wall thickness. piece came out at 2.94 wall thickness. Also see how the layers seprate sometimes. How do i prevent that?]]>https://www.soliforum.com/user/7171/2014-12-29T15:14:19Zhttps://www.soliforum.com/post/76839/#p76839<![CDATA[Re: Calibrate flow rate]]>well. Used my dial calipers and found out the filament is extruding at .43 mm thick. then I printed a cbe with 25 mm wall thickness.]]>https://www.soliforum.com/user/7171/2014-12-29T15:14:13Zhttps://www.soliforum.com/post/76838/#p76838<![CDATA[Re: Calibrate flow rate]]>Print a cube with 0 fill and 1 perimeter, stop before it gets to the top. The wall thickness should match the extrusion width. If it doesn't, change the extrusion multiplier. If the wall needs to be 10% thinner, reduce the extrusion multiplier 10%.]]>https://www.soliforum.com/user/14/2014-12-27T14:56:15Zhttps://www.soliforum.com/post/76631/#p76631<![CDATA[Calibrate flow rate]]>How do I get my flow rate right? I have very accurate calipers just need to know what to do.]]>https://www.soliforum.com/user/7171/2014-12-27T13:34:02Zhttps://www.soliforum.com/post/76622/#p76622