Pretty sure you have a sang board

Dandean wrote:

In wiki instructions it say that soliddoodle always put their own label over processor number, so I peeled it off to get number underneath. Underneath is # ATMega 664P   I got sd2 1/1/13
I just looked to see if I still have label and could not find.

+1

This is a Printrboard

This is a Sanguinololu

No need to delete anything. RH would have zero accountability for your experiences.
The best place to start is by identifying which board you have.

After installing new hot end I downloaded repitier update since I had never updated since I got printer originally.  I was able to move print head x and y. But after that  I cannot even do that

New power supply does work as I have power to fan. Should I delete all downloads and repitier   And start all over from scratch. Seem like there's so much stuff in download folder.

wardjr wrote:

if you still can't figure it out I'll do it but you'll have to remove the board and ship it to me.

What a guy!

Says the guy stuck using my old Sang

if you still can't figure it out I'll do it but you'll have to remove the board and ship it to me.

What a guy!

Have sd2, installed e3d extruder ,thermistor and new power supply. I tried to download all new firmware and haven't been able to get past first base. Seems like I'm going backwards.  I would be willing to ship printer,laptop to someone to get it up and running. I know how to use repieter and all that but can't get the programming needed on this upgrade   Quote me the cost

What board do you have?  Once we know that we can point you to the step by step instructions.
If after that, if you still can't figure it out I'll do it but you'll have to remove the board and ship it to me.