<![CDATA[SoliForum - 3D Printing Community — Wow.]]> 2014-12-16T19:22:52Z PunBB https://www.soliforum.com/topic/8765/wow/ <![CDATA[Re: Wow.]]> Just did 220C (should be actual, using an E3D) and it worked extremely well. A little bit of stringiness but over all a very very nice print. Also no warp whatsoever. smile The bed was at 95C but this caused the bottom of the print to spread out a bit so lower is probably good. Bed material is hairspray on glass.

]]> https://www.soliforum.com/user/1669/ 2014-12-16T19:22:52Z https://www.soliforum.com/post/75453/#p75453 <![CDATA[Re: Wow.]]> I have had various degrees of success with T- glass The latest try was at 265C for the hotend and 70C bed temp.I just used blue painters  tape.The print did fairly well. What  temps did you use?

]]> https://www.soliforum.com/user/574/ 2014-12-16T04:25:23Z https://www.soliforum.com/post/75385/#p75385 <![CDATA[Wow.]]> Around eight months ago I decided to try out the Taulman tglase filament. After many many failed prints, weird filament texture, extreme lack of parts sticking to bed, and extruder gear jams of knotted filament, I gave up and went back to ABS.

Then today, when a PLA print jammed (YET AGAIN...) I decided to pop in the tglase.

Works like a charm. Perfect sticking. Excellent quality. No issues. What the heck happened tongue.

Just surprised.

]]> https://www.soliforum.com/user/1669/ 2014-12-16T03:17:28Z https://www.soliforum.com/post/75375/#p75375