<![CDATA[SoliForum - 3D Printing Community — question about printing a vase]]> 2014-12-11T21:26:26Z PunBB https://www.soliforum.com/topic/8698/question-about-printing-a-vase/ <![CDATA[Re: question about printing a vase]]> In my experience, 1 perimeter is usually not enough to make a vase worth having.  It will be very weak.  With a 0.4 mm nozzle, your width is probably about 0.48 mm and that is just not a lot of plastic and it is going to be flimsy.  Not to mention if your vase has steep sides you might even get gaps.  For a decent sized vase that takes up most of my build plate I would use at least three perimeters.  This does mean not spiral vase settings but oh well.

]]> https://www.soliforum.com/user/4377/ 2014-12-11T21:26:26Z https://www.soliforum.com/post/74870/#p74870 <![CDATA[Re: question about printing a vase]]> I am using Makerbot Desktop which is a proprietary software.

]]> https://www.soliforum.com/user/187/ 2014-12-11T01:28:22Z https://www.soliforum.com/post/74773/#p74773 <![CDATA[Re: question about printing a vase]]> If you're using slic3r you can use the "spiral vase" setting.

]]> https://www.soliforum.com/user/2291/ 2014-12-11T00:21:16Z https://www.soliforum.com/post/74763/#p74763 <![CDATA[question about printing a vase]]> I haven't tried to print something like a thin wall vase on my Makerbot 2X
My nozzle Dia. is .4mm
can i get a good print with .2mm Layer thickness, 1 shell wall thickness, 0 infill,

here is what I wanted to print
http://www.thingiverse.com/thing:184635

]]> https://www.soliforum.com/user/187/ 2014-12-11T00:18:23Z https://www.soliforum.com/post/74761/#p74761