SoliForum - 3D Printing Community — print lifting off bed any suggestions

Re: print lifting off bed any suggestions

2015-01-10T09:43:51Z

Any suggestions about designing ??

Re: print lifting off bed any suggestions

2015-01-10T06:20:33Z

I've had very good success with acetone on a paper towel. Then you rub it on scrap plastic until a light coating is on the paper towel. Add more acetone to the paper towel with the plastic residue, and wipe the bed with it. I can barely remove my prints, usually have to press the kapton down after as it pulls up a little. I have my bed temp at 110C

Re: print lifting off bed any suggestions

2014-11-13T00:50:12Z

Try the temp closer toward 240. I'm not familiar with the Makerbot hotends or the placement of their thermistors, so use some caution when doing this.
The 40% should not be effecting this at all. And bed temp looks good.

Have you adjusted your Z tab? You want it to look like a fat, flat ribbon.
If this is still not working out, there are many alternative printing surfaces, BuildTak, PrintinZ, and a simple glass with hairspray as mentioned.

Re: print lifting off bed any suggestions

2014-11-12T23:02:42Z

using ABS, nozzle temp 230°, 40% infill , bed temp 100°.

Re: print lifting off bed any suggestions

2014-11-12T22:58:07Z

What material are you printing with and what are the temps settings you are using?
Also, what is your current infill setting?

From the looks of it, you are a good candidate for glass and hairspray. I never could print directly onto kapton and always had that exact problem.

print lifting off bed any suggestions

2014-11-12T22:55:45Z

I have tried to print this twice and it keeps lifting off the bed and getting knocked off by the nozzle.
my print settings are 4 layers 40% infill
I have scuffed up the Kapton with 240 grit paper and wiped down with acetone.
is the infill and No. of layers causing the problem.