SoliForum - 3D Printing Community — Need to run an idea through the gauntlet .... abs bed frame .......

Re: Need to run an idea through the gauntlet .... abs bed frame .......

2014-11-08T19:51:16Z

The heater lays between the ABS parts and the glass.

Re: Need to run an idea through the gauntlet .... abs bed frame .......

2014-11-08T18:21:17Z

Boz wrote:

I've used an ABS platform for my heatbed that has a QU-BD heatpad right on top that generally runs at 95°C. So far I do not see any problems with it at all, and I have had in on there for several months.

That passes the heat through the abs ok???

Re: Need to run an idea through the gauntlet .... abs bed frame .......

2014-11-08T16:17:37Z

I've used an ABS platform for my heatbed that has a QU-BD heatpad right on top that generally runs at 95°C. So far I do not see any problems with it at all, and I have had in on there for several months.

Re: Need to run an idea through the gauntlet .... abs bed frame .......

2014-11-08T05:33:19Z

I used to use clips but now I just use hair spray on the underside of the glass, works well no slipping.

Need to run an idea through the gauntlet .... abs bed frame .......

2014-11-08T04:46:05Z

Ok heres my thing. just got a piece of 1/4 inch pyrex for the bed. the size clips i need to keep it on there are WAY to big and cause problems. so my though was to make an abs frame with an door on the front to slide the glass out of when i need to. i figure that abs needs 221 to melt and the bed with never go above 100 so this should work correct?