SoliForum - 3D Printing Community — Repetier and filament replacement

Re: Repetier and filament replacement

2012-12-18T02:41:53Z

Thanks to Nickthegreek, found it. I'm off to my next challenge, will post it as a new item Repetier: Unknown printer firmware

Re: Repetier and filament replacement

2012-12-17T20:58:10Z

Not familiar with repetier on the mac, but....

On the windows version, not all of the controls are immediately visible on the manual control tab.
See if you have a scroll bar on the sides - you might have to scroll the extrude/retract buttons into view.

Re: Repetier and filament replacement

2012-12-17T04:06:09Z

On the Print Panel tab in Reptier-Host-Mac you will see 'Extrude' and 'Retract'.

Under Extruder:
Put Temperature input to 200 and click 'Set Temp' (Heat On button should light up, if not click it)
Set 'Extrude' input and 'Retract' input to 5.

Once extruder is at 200, then you can use those buttons to load your filament as per the instructions on the SD site.

Repetier and filament replacement

2012-12-17T02:48:37Z

After spending a couple weeks trying to get my SD2 to work with my MAC, I surrendered and put it aside for a few months. I recently saw the posts on using Repetier so thought I would give it another try. So far I've managed to update the Marlin drivers and have Repetier working. Now to put filament in the puppy and see if I can get something out :-). I went to the SD site for instruction but the steps there are for Pronterface. In Pronterface there are buttons for Extrude and Reverse. I haven't found similar buttons in Repetier. Is there a way I missed or do I need to use Pronterface to install the filament?