SoliForum - 3D Printing Community — Slic3r share your Configuration

Re: Slic3r share your Configuration

2014-10-30T21:27:05Z

Ghostling wrote:

in my experience, different filament need to print with different temperatures. i just figure it out with trial and error.
My white ABS i print at 210, black i print at 200.... bed always at 100.
too low i get bad lamination, too high i get bad curling...

+1 Red seems to melt easyest for some reason

Re: Slic3r share your Configuration

2014-10-30T19:26:20Z

in my experience, different filament need to print with different temperatures. i just figure it out with trial and error.
My white ABS i print at 210, black i print at 200.... bed always at 100.
too low i get bad lamination, too high i get bad curling...

Re: Slic3r share your Configuration

2014-10-30T03:25:20Z

really depends what your printing so need to include that with presets. I have 24 different presets so far and change or add often to achieve best results on item printed and I do several dif types. some customer orders through my 3Dhubs.com hub

Re: Slic3r share your Configuration

2014-10-29T12:39:54Z

Looks to me like your temp it too high. I run about 200 for extruder, 85 for bed, using ABS.
I use 2 perimeters, 15% infill, 2 tops, 2 bottoms for printing at .3mm.

Slic3r share your Configuration

2014-10-29T00:13:30Z

I have a solidoodle4 and use Slic3r. I was wondering if anyone would be will to export their configuration (one that works good)and share it with me. I am getting ok prints but think they could be better, hopping to look at other configurations and get ideas on what to try and change. I have attached one that I have been using if someone wants to look it over and give suggestions.
Thanks
Chad