<![CDATA[SoliForum - 3D Printing Community — how to determine firmware version]]> 2012-12-17T22:03:12Z PunBB https://www.soliforum.com/topic/815/how-to-determine-firmware-version/ <![CDATA[Re: how to determine firmware version]]> dolmademike wrote:

Have you tried the .1mm Repetier setup?

I do all of my printing using Repetier Host at 0.1mm

]]> https://www.soliforum.com/user/181/ 2012-12-17T22:03:12Z https://www.soliforum.com/post/7365/#p7365 <![CDATA[Re: how to determine firmware version]]> Thanks The OldMan! It looks like I have current firmware as expected.

Have you tried the .1mm Repetier setup?

to NickytheGree --- efkaristo wink

]]> https://www.soliforum.com/user/393/ 2012-12-17T20:07:10Z https://www.soliforum.com/post/7357/#p7357 <![CDATA[Re: how to determine firmware version]]> Read the startup mesage when you first connect. It shows the firmware version.

]]> https://www.soliforum.com/user/257/ 2012-12-17T04:14:15Z https://www.soliforum.com/post/7323/#p7323 <![CDATA[Re: how to determine firmware version]]> I got my printer in early november and it already had the newer firmware, so I would assume yours would have to be the newest as well.

]]> https://www.soliforum.com/user/366/ 2012-12-17T02:20:47Z https://www.soliforum.com/post/7314/#p7314 <![CDATA[how to determine firmware version]]> Is there any way to tell what version of firmware I have?

I don't want to muck with arduino if I have the latest, and I do have a printer that just arrived in early December, so I expect I do. I ask because I tried the Repetier Host setup under the .1mm instructions and it was just awful. The stock Pronterface+ skeinforge worked great at .3mm. The Repetier setup just made terrible edges and the fill was even poor. So I'm guessing maybe I have old firmware?

thx

]]> https://www.soliforum.com/user/393/ 2012-12-17T00:51:49Z https://www.soliforum.com/post/7309/#p7309