<![CDATA[SoliForum - 3D Printing Community — Bed leveling tip]]> 2014-10-17T11:02:48Z PunBB https://www.soliforum.com/topic/8020/bed-leveling-tip/ <![CDATA[Bed leveling tip]]> I just replaced the 3 bed leveling thumb nuts with 3mm wing nuts.
They were a bit fiddly to fit but once on, the wings provide a visual gauge making it easier to judge the amount of adjustment when leveling the bed.
Not sure if it was just a coincidence but after running the first calibration after fitting the wing nuts, I managed to get my first Z offset of 250 !
Before then, the best I had managed was 260.


http://i882.photobucket.com/albums/ac28/scobodon/imagejpg1_zps5b723104.jpg

]]> https://www.soliforum.com/user/6872/ 2014-10-17T11:02:48Z https://www.soliforum.com/post/68884/#p68884