SoliForum - 3D Printing Community — Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

Re: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

2012-12-15T20:38:50Z

Thanks Devilman, it's all installed and ready to go, that is, when I get the Kapton Tape on Monday. Otherwise it's firmware upgraded and new software installed.

Re: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

2012-12-15T20:26:33Z

Somewhere I got the impression they were picked up automatically by Slc3r and displayed in a drop down list. This isn't the case?

Re: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

2012-12-15T20:23:45Z

You don't need to put them anywhere specific. Personally I made a folder for all the slicer config files I have butyoujust need to load the profiles, it doesn't matter where they are

Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

2012-12-15T20:13:10Z

I've gotten past all my past issues except I'm waiting for the Kapton tape. In the meantime I thought I'd finish installing the Repetier-Host software on my laptop which will be the control computer for the SD2. Trouble is I can't find where to locate the two ini files necessare for switching between .1mm and .3mm printing. I know this was specified somewhere but I can't find that reference after searching this Forums and also re-reading over and over the installation instructions.

Can someone tell me which sub-directory that these files need to be placed in under Slc3r? I'n not finding any sub-directories with 'ini' extension files.