SoliForum - 3D Printing Community — Firmware upgrade Compile Error

Re: Firmware upgrade Compile Error

2012-12-15T20:06:34Z

Finally got the Firmware updated. Seems it takes a lot longer than I was lead to believe. About a minute or more. But that part
is done now.

Re: Firmware upgrade Compile Error

2012-12-15T02:01:41Z

Well, the first issue was my doing, or not doing. I didn't Open the Martin.PDE file.

But, it's not uploading no matter which method I use. I get an error message that it can't upload. My machine is OLD I feel as things like the Extrusion Head have to be totally disassembled in order to work on the Hot End not like in the new video. Also whoever assembled this machine LOVED to throw grease around as there is enough grease inside to service at lease three machines. It's on everything including the belts in some places. It's hard to work in there without getting some on you. I guess eventually I'll get rid of the excess by wiping it on paper towels as I work on the machine.

I have one of the new chips coming in from the UK. Hopefully that will solve the firmware upload issue.

Re: Firmware upgrade Compile Error

2012-12-15T01:03:28Z

The above error was from my desktop attached to the SD 2. I then set the firmware upgrade software on to my laptop and I received the same errors. Evidently there is an issue with the Sanguino files.

Anyone have a solution for this?

Firmware upgrade Compile Error

2012-12-14T23:13:54Z

I tried doing the update on the installed chip but got this error in Arduino 0022:

Error compliling.

core.a(main.cpp.o): In function 'main':
C:\SolidoodleFirmare\arduion-022\hardware\Sanguino\cores\cpp: 7: undefiend reference to 'setup'
C:\SolidoodleFirmare\arduion-022\hardware\Sanguino\cores\cpp: 10: undefiend reference to 'loop'

I just downloaded everything a short time ago so it's recent.