<![CDATA[SoliForum - 3D Printing Community — Diagonal Pattern Issue]]> 2014-10-04T18:36:34Z PunBB https://www.soliforum.com/topic/7897/diagonal-pattern-issue/ <![CDATA[Re: Diagonal Pattern Issue]]> BTW, this is a SD2

]]> https://www.soliforum.com/user/417/ 2014-10-04T18:36:34Z https://www.soliforum.com/post/67628/#p67628 <![CDATA[Re: Diagonal Pattern Issue]]> Thanks.

First I tested it and it was ~190mV.
Then I printed the test cube at 150mV, 170mV, 200mV, 230mV and 270mV. The results were always the same.
Should I try even higher or lower? Or should I try smaller increments?

]]> https://www.soliforum.com/user/417/ 2014-10-04T18:36:17Z https://www.soliforum.com/post/67627/#p67627 <![CDATA[Re: Diagonal Pattern Issue]]> Moire. You can use a ceramic or other non-conductive screwdriver to adjust the VREF on the board (the one that says E). Only a tiny turn is needed, though.

]]> https://www.soliforum.com/user/4188/ 2014-10-04T17:08:52Z https://www.soliforum.com/post/67622/#p67622 <![CDATA[Diagonal Pattern Issue]]> Heya,

A couple of days ago I started noticing these patterns on my prints. Any ideas what may cause this?

]]> https://www.soliforum.com/user/417/ 2014-10-04T17:00:12Z https://www.soliforum.com/post/67621/#p67621