SoliForum - 3D Printing Community — Printing problem

Re: Printing problem

2014-09-19T09:06:15Z

Dear All,

thank you very much for valuable advice. i will try all the advices.

for sure, i had already calibrated the extruder. but some suggestion still not yet try.

thank you

2014-09-18T20:23:32Z

wire10ga wrote:

Have you done the extruder calibration yet?

These should help you:

http://www.soliforum.com/topic/2962/dis … p-filling/
Note that relating to this last link, if you are using a .4mm nozzle, the extruded strand width should be around 0.48mm...

2014-09-18T17:09:18Z

Have you done the extruder calibration yet?

2014-09-18T13:18:11Z

wheres the infil? is it turned off in slicer? need at min 15% I use 30 on most settings

2014-09-18T12:00:56Z

hi,

Please advice what is the problem of my printing, please refer to attachment

I use PLA, the wall is 2mm, but the filament not joining.

Please advice