<![CDATA[SoliForum - 3D Printing Community — calibration cube]]> 2014-09-08T04:10:34Z PunBB https://www.soliforum.com/topic/7623/calibration-cube/ <![CDATA[Re: calibration cube]]> grob wrote:

Normally I use a plain 20mm cube (solid), and instruct slic3r to perform about 2 bottom layers (make sure it sticks...), 0 top layers, just 1 perimeter and 0% infill.

I usually create this profile from my existing normal profile, so it picks up all the other settings identically for a fair comparison!

+1

]]> https://www.soliforum.com/user/2291/ 2014-09-08T04:10:34Z https://www.soliforum.com/post/65735/#p65735 <![CDATA[Re: calibration cube]]> Normally I use a plain 20mm cube (solid), and instruct slic3r to perform about 2 bottom layers (make sure it sticks...), 0 top layers, just 1 perimeter and 0% infill.

I usually create this profile from my existing normal profile, so it picks up all the other settings identically for a fair comparison!

]]> https://www.soliforum.com/user/4515/ 2014-09-07T23:48:20Z https://www.soliforum.com/post/65714/#p65714 <![CDATA[Re: calibration cube]]> ok found right box and test print came out to .41mm all 4 sides

]]> https://www.soliforum.com/user/795/ 2014-09-07T03:36:28Z https://www.soliforum.com/post/65647/#p65647 <![CDATA[calibration cube]]> is the right stl file a complete cube or an open top box? all I found was closed hollow cube and cant get Slic3r to stop making a raft, 10 layers bottom and 2 perimiters no matter how many times I try and reset save re-slice.

]]> https://www.soliforum.com/user/795/ 2014-09-07T02:32:15Z https://www.soliforum.com/post/65642/#p65642