<![CDATA[SoliForum - 3D Printing Community — Cleaning print bed]]> 2014-09-08T03:25:35Z PunBB https://www.soliforum.com/topic/7603/cleaning-print-bed/ <![CDATA[Re: Cleaning print bed]]> I find I get better results cleaning the bed before every print.....I am also using Elmers extra strength glue sticks.... Wet a rag with warm water and ring it out, then just wipe the bed off......

]]> https://www.soliforum.com/user/6940/ 2014-09-08T03:25:35Z https://www.soliforum.com/post/65734/#p65734 <![CDATA[Re: Cleaning print bed]]> I have a Replicator 2X I print ABS on Kapton tape.
I wipe the bed while cold before each print.

]]> https://www.soliforum.com/user/187/ 2014-09-04T23:28:44Z https://www.soliforum.com/post/65441/#p65441 <![CDATA[Cleaning print bed]]> Does everyone clean the print bed after every print? I have been cleaning my bed about once a month so I am getting quiet a build up glue. Which has been working great especially since I switched to Elmer's Extra Strength glue stick. I just feel like there is something I am missing to make sure that I am getting the best quality prints that I can or I might be ruining the printer.

Attached is my most recent print on low settings.

]]> https://www.soliforum.com/user/7201/ 2014-09-04T23:21:09Z https://www.soliforum.com/post/65437/#p65437