<![CDATA[SoliForum - 3D Printing Community — Can I use Simplify 3D?]]> 2014-08-31T23:00:27Z PunBB https://www.soliforum.com/topic/7530/can-i-use-simplify-3d/ <![CDATA[Re: Can I use Simplify 3D?]]> wire10ga wrote:

If you changed the firmware, if you can run Repetier Host on it now, then I would guess that it should work.


Thats kind of what im thinking also , I just don't want to waste $140.......was hoping someone here would know for sure......

]]> https://www.soliforum.com/user/6940/ 2014-08-31T23:00:27Z https://www.soliforum.com/post/65025/#p65025 <![CDATA[Re: Can I use Simplify 3D?]]> Per their printer support page, it says it will take the G-code on SD card but not drive it drive it directly.
http://www.simplify3d.com/software/supported-printers/  If you changed the firmware, if you can run Repetier Host on it now, then I would guess that it should work.

]]> https://www.soliforum.com/user/134/ 2014-08-31T21:40:32Z https://www.soliforum.com/post/65021/#p65021 <![CDATA[Can I use Simplify 3D?]]> Don't want to spend the money till I'm sure I can use it...... I'm running a Davinci 1.0 that has been flashed with Repetier firmware...... Anybody know if this will work?

Thanks

]]> https://www.soliforum.com/user/6940/ 2014-08-31T14:51:01Z https://www.soliforum.com/post/64997/#p64997