SoliForum - 3D Printing Community — Da Vinci 2.0: Filament Jam

Re: Da Vinci 2.0: Filament Jam

2014-08-28T08:33:00Z

Make sure you feeding it through the feed holes under the top lid, I did not see those at first, and the lid might be catching your filament in there.

Mine is working incredible! Loving it, but still need to hard this baby

Re: Da Vinci 2.0: Filament Jam

2014-08-23T14:55:13Z

I never change the temp or other settings. I just reloaded the cartridge and cut off about a foot. Same problem - printing started and stopped/jam. I checked the calibration and it was FAIL (way off), after I re-calibrated it, I was able to print the Key Chain (quality wasn't good but it completed.

However, I am having problem to print other sample like vase - it's clogging the nozzle in the middle of the job.....

Thanks all!

Re: Da Vinci 2.0: Filament Jam

2014-08-23T01:50:09Z

Did you alter the temperature by any chance? If not I would recommend unloading the filament, cut about a foot or 2 off the spool and try to load it again

Re: Da Vinci 2.0: Filament Jam

2014-08-23T01:30:41Z

Yes, I did remove the plugs from the cartridge and the filament come out fine - only that it will stop after few minutes.

I read some post about the speed of the print, is there something I need to adjust?

Re: Da Vinci 2.0: Filament Jam

2014-08-23T01:18:27Z

Make sure the rubber plug has been pulled from the cartridge

Re: Da Vinci 2.0: Filament Jam

2014-08-23T01:14:08Z

Toka wrote:

p.s. I am using the xyz filaments come with the printer.

Does the filament feed properly? Sometimes the desicant packets can get dislodged in the cartridge blocking the filament feeding.

Re: Da Vinci 2.0: Filament Jam

2014-08-23T00:56:09Z

p.s. I am using the xyz filaments come with the printer.

Da Vinci 2.0: Filament Jam

2014-08-23T00:55:31Z

Received my Da Vinci 2.0 printer today, and installed the filaments without any issue. However, when I tried to print the sample comes with the printer or any STL via USB, it will print for few minutes and stop with "filament1 jam" error. If I continue with another job, no filament will come out. Then, I managed to clean the nozzle and unclogged it. When I print again, filament will come out and act normal for few minutes and then stop -- same problem/cycle; I tried at least 5 or 6 times. Any idea?