<![CDATA[SoliForum - 3D Printing Community — Hello everyone! received my DaVinci 1.0 yesterday!]]> 2014-08-15T17:27:11Z PunBB https://www.soliforum.com/topic/7324/hello-everyone-received-my-davinci-10-yesterday/ <![CDATA[Re: Hello everyone! received my DaVinci 1.0 yesterday!]]> thanks, i just ordered a rice cooker and acetone, going to play with that this WE.
meanwhile i did a bit or dremel action yesterday night, (30 minutes or so).
I'm pretty sure just by sanding i could get close to their result but it would take too long, hopefully the acetone going to give the finish look!

attached a before and after, i guess i can't link the image directly for now.

]]> https://www.soliforum.com/user/6933/ 2014-08-15T17:27:11Z https://www.soliforum.com/post/63420/#p63420 <![CDATA[Re: Hello everyone! received my DaVinci 1.0 yesterday!]]> Just an opinion that other peoples may differ a lot from smile

To get closer to the Shapeways quality level your going to need to print at 1mm layers and Excellent (aka slow) if using XYZware.

After that you will need to use vapor smoothing (after sanding off any support marks and other imperfections). There are long acetone vapor smoothing threads in this forum.

The combination of those two things will get you very close to the quality level your trying to match.

]]> https://www.soliforum.com/user/6245/ 2014-08-14T21:13:45Z https://www.soliforum.com/post/63301/#p63301 <![CDATA[Hello everyone! received my DaVinci 1.0 yesterday!]]> so i wanted to say hi!
this is the first model i printed (after bunch of bad tests). this is at 200, with support and it's around 5cm tall. around 1.5hours of printing.
on the last photo my print is next to the one i ordered from Shapeways in sandstone, next step is to get my print as close as i can to it.

]]> https://www.soliforum.com/user/6933/ 2014-08-14T18:50:41Z https://www.soliforum.com/post/63294/#p63294