SoliForum - 3D Printing Community — first day at the 3d printer

Re: first day at the 3d printer

2014-08-19T04:45:45Z

tonycstech wrote:

320c heat bed ? no way ! Thats hotter then nozzle.
I'd like to have that temperature when printing ABS
Permanent warp solution L)

right
, my bad
, thats the extruder temp...the set up for the heat bed is 60 for pla and 120(ithink) for ABS..

Re: first day at the 3d printer

2014-08-19T04:40:04Z

320c heat bed ? no way ! Thats hotter then nozzle.
I'd like to have that temperature when printing ABS
Permanent warp solution L)

Re: first day at the 3d printer

2014-08-19T03:49:32Z

tonycstech wrote:

LOL 1st picture is like print quality evolution LOL
What kind of printer is this, is it any good ?
What is its max build volume and does it have direct feed or bowden feed ?
HEat bed ?
thanks !

its an AirWold HDx, im not sure if is any good, its the first and only 3d printer i have ever seen and use,,,so i have nothing to compare it with but so far so good... it has nice LED lights..
here you can read abut this printer

http://airwolf3d.com/store/products/lar … l-aw3d-hd/

heat bed, sure up to 320 C...
cheers!

Re: first day at the 3d printer

2014-08-18T04:56:08Z

LOL 1st picture is like print quality evolution LOL
What kind of printer is this, is it any good ?
What is its max build volume and does it have direct feed or bowden feed ?
HEat bed ?

thanks !

first day at the 3d printer

2014-08-08T00:16:53Z

so i figure the best way to learn, is to start small and build on to that... so most of the day i try to print this basic pieces i did in cinema, after alot of basic mistakes, once i got this 1cm pz (4 in) righ i "push it a little"and try the same piece on half the scale..wich is close to the printer specs...., .5cm ( 2 in)... at the end i was very happy with both results..... so tomorrow i can move on to bigger more complex shapes.... i share some pictures and screen captures of this process,,, very helpful practice