<![CDATA[SoliForum - 3D Printing Community — Solidoodle risers to store power supplies]]> 2014-08-01T11:36:35Z PunBB https://www.soliforum.com/topic/7126/solidoodle-risers-to-store-power-supplies/ <![CDATA[Re: Solidoodle risers to store power supplies]]> +1

]]> https://www.soliforum.com/user/134/ 2014-08-01T11:36:35Z https://www.soliforum.com/post/61686/#p61686 <![CDATA[Re: Solidoodle risers to store power supplies]]> Are these available on Thingiverse?

]]> https://www.soliforum.com/user/2351/ 2014-08-01T03:12:23Z https://www.soliforum.com/post/61664/#p61664 <![CDATA[Solidoodle risers to store power supplies]]> I made these risers so I could mount power supplies to the bottom of my SD3 . They raise it up 5 inches ,are built to be very robust. I printed them at.3mm and .2 infill feed rate 120 % . They take 13 + hours each to print. I then glued Neo magnets to the tops and small rubber feet to the bottoms.



If I can figure it out I will post picture

]]> https://www.soliforum.com/user/5384/ 2014-07-29T20:10:32Z https://www.soliforum.com/post/61434/#p61434