<![CDATA[SoliForum - 3D Printing Community — Nodules? Lumps? Blobs? AH! THE BLOB! RUN!!]]> 2014-07-28T23:50:41Z PunBB https://www.soliforum.com/topic/7110/nodules-lumps-blobs-ah-the-blob-run/ <![CDATA[Re: Nodules? Lumps? Blobs? AH! THE BLOB! RUN!!]]> What's the internet wink

]]> https://www.soliforum.com/user/2291/ 2014-07-28T23:50:41Z https://www.soliforum.com/post/61383/#p61383 <![CDATA[Re: Nodules? Lumps? Blobs? AH! THE BLOB! RUN!!]]> Ah...... Nope!
Swapped back down the 1.1.5 and it seems the problem has gone away.
Weird.

Thanks comrade!

]]> https://www.soliforum.com/user/3013/ 2014-07-28T23:48:28Z https://www.soliforum.com/post/61381/#p61381 <![CDATA[Re: Nodules? Lumps? Blobs? AH! THE BLOB! RUN!!]]> Have you tried a different slicer?

]]> https://www.soliforum.com/user/55/ 2014-07-28T15:50:09Z https://www.soliforum.com/post/61366/#p61366 <![CDATA[Nodules? Lumps? Blobs? AH! THE BLOB! RUN!!]]> I've tried futzing with just about every setting in slic3r..
Getting rather odd blobs on the sides of prints, curiously it only appears on the outward facing walls if I've got more than one object on the print bed.
Happens with both PLA and ABS so temp isn't the problem. Think I've also ruled out over/under extruding too.
http://i.imgur.com/vurVlol.jpg

Any advice will be repaid in internet points which can be spent at the internet.
tongue

Cheers!

]]> https://www.soliforum.com/user/3013/ 2014-07-28T12:23:41Z https://www.soliforum.com/post/61357/#p61357