SoliForum - 3D Printing Community — SD2 extruding problems

Re: SD2 extruding problems

2014-07-20T06:02:00Z

It all depends on your desire to tinker. The physical installation isn't bad but depending on what board you have, firmware changes can be challenging. Either way plenty of people have figured it out so I'm sure you can as well.

Re: SD2 extruding problems

2014-07-20T03:53:25Z

Thanks for both of your answers, but I was looking at the E3D and saw that the set up is kind of long and seems scary. Is it actually that difficult?

Re: SD2 extruding problems

2014-07-19T23:30:13Z

GaryTheWhale wrote:

Taking apart the acrylic is getting annoying, and i was wondering if anyone can help me prevent this.
Thanks in advance

http://www.thingiverse.com/thing:111213
Also, do yourself a favor and buy an E3D from Filastruder.com
You actually have to try pretty hard to clog them. The MK5 extruder is one of the best out there. They are also available for purchase at Filastruder for $5

Re: SD2 extruding problems

2014-07-19T22:59:00Z

I know that if you dont keep the material moving it will stay put, so I always extrude a little filiment manually every 4-5 mins that I'm not printing (maybe even sooner) and I keep my idle time pretty low too.

SD2 extruding problems

2014-07-19T22:41:05Z

My solidoodle 2 is getting jammed after every print, and the drive gear is not pushing any filament out. Taking apart the acrylic is getting annoying, and i was wondering if anyone can help me prevent this.
Thanks in advance