SoliForum - 3D Printing Community — Unable to reach 250 degrees

Re: Unable to reach 250 degrees

2014-07-21T03:44:21Z

Thanks guys! It is all working great.

Re: Unable to reach 250 degrees

2014-07-20T06:04:43Z

Yep... Make the changes in firmware and then run at 240 - 250 for ABS

Re: Unable to reach 250 degrees

2014-07-19T23:24:35Z

elmoret wrote:

exineport wrote:
A little toasty for abs IMHO. I run 205-215 (maybe at most 220 to get those layers together) but I'm pretty new still.
You're using a completely different hotend which measures temperature in a different location.

My bad, disregard.

Re: Unable to reach 250 degrees

2014-07-19T23:21:29Z

exineport wrote:

A little toasty for abs IMHO. I run 205-215 (maybe at most 220 to get those layers together) but I'm pretty new still.

You're using a completely different hotend which measures temperature in a different location.

Re: Unable to reach 250 degrees

2014-07-19T23:08:11Z

A little toasty for abs IMHO. I run 205-215 (maybe at most 220 to get those layers together) but I'm pretty new still.

Re: Unable to reach 250 degrees

2014-07-19T20:06:28Z

Sounds to me like you never flashed the board like you were supposed to. That also means you've ben running on the wrong thermistor setting.

Good times.

Unable to reach 250 degrees

2014-07-19T19:53:01Z

I have been printing with PLA since I got the printer, so I set my printer to 210 and that worked out fine. Once I got some ABS, I tried printing at 250. The printer would go fine until it reached 236 and the it would stop and start to drop. I am using a e3d v6 and the original solidoodle board.