2014-07-04T17:40:40Z PunBB https://www.soliforum.com/topic/6902/level-the-bed-with-the-wingnuts/ If your printer has the wingnuts, you can just turn them to level the bed.  The video is a bit dated!

]]> https://www.soliforum.com/user/131/ 2014-07-04T17:40:40Z https://www.soliforum.com/post/59786/#p59786 Newbie question here.  The official Solidoodle leveling video says to poke holes in the kapton and run the three bed screws in.  But then I noticed that the printer in the video doesn't have wingnuts on the bottoms of those screws and my printer does.  Can't I just tighten/loosen the wingnuts to lower/raise the bed, or am I missing something?

]]> https://www.soliforum.com/user/6248/ 2014-07-04T17:19:06Z https://www.soliforum.com/post/59784/#p59784