<![CDATA[SoliForum - 3D Printing Community — Nylon flexibility]]> 2014-07-03T10:55:23Z PunBB https://www.soliforum.com/topic/6881/nylon-flexibility/ <![CDATA[Re: Nylon flexibility]]> I also found out that, even though it is not the same, the plastic industry also uses the Flexural Modulus:
http://www.efunda.com/forum/show_messag … amp;id=825

]]> https://www.soliforum.com/user/3986/ 2014-07-03T10:55:23Z https://www.soliforum.com/post/59698/#p59698 <![CDATA[Re: Nylon flexibility]]> Thank you guys! That's exactly what I was looking for!

]]> https://www.soliforum.com/user/3986/ 2014-07-03T10:41:48Z https://www.soliforum.com/post/59697/#p59697 <![CDATA[Re: Nylon flexibility]]> elmoret wrote:

Young's modulus.

Low = flexible
High = stiff

smile

]]> https://www.soliforum.com/user/4515/ 2014-07-03T05:20:27Z https://www.soliforum.com/post/59684/#p59684 <![CDATA[Re: Nylon flexibility]]> Young's modulus.

]]> https://www.soliforum.com/user/221/ 2014-07-02T20:18:00Z https://www.soliforum.com/post/59653/#p59653 <![CDATA[Nylon flexibility]]> Hello everyone!

What parameter should I use to measure if a Nylon filament is going to be more flexible than other?

Like Nylon6, 6.6 , 11... 12?

Thank you! Best Regards.

]]> https://www.soliforum.com/user/3986/ 2014-07-02T19:27:15Z https://www.soliforum.com/post/59650/#p59650