<![CDATA[SoliForum - 3D Printing Community — Slic3r supports]]>2014-07-05T18:19:07ZPunBBhttps://www.soliforum.com/topic/6742/slic3r-supports/<![CDATA[Re: Slic3r supports]]>The cura settings? I will have to look, I don't think I did anything special besides making the first move a g1 z5 so that on the first rapid it did not bang the glass with the interpolated xyz simultaneous move.]]>https://www.soliforum.com/user/5588/2014-07-05T18:19:07Zhttps://www.soliforum.com/post/59815/#p59815<![CDATA[Re: Slic3r supports]]>joshj wrote:
I have done 8+ hour prints with no issues. If there is an issue it is not specifically with cura. It only is a gcode generator after all.
hi did you publish your settings anywhere, i'd love to run with cura but i still have Z axis issue thanks
]]>https://www.soliforum.com/user/5637/2014-07-05T16:16:47Zhttps://www.soliforum.com/post/59807/#p59807<![CDATA[Re: Slic3r supports]]>I have done 8+ hour prints with no issues. If there is an issue it is not specifically with cura. It only is a gcode generator after all.]]>https://www.soliforum.com/user/5588/2014-06-22T21:50:42Zhttps://www.soliforum.com/post/59117/#p59117<![CDATA[Re: Slic3r supports]]>I read into it, isn't there an issue with cura stopping halfway thru the print?]]>https://www.soliforum.com/user/6031/2014-06-22T03:16:02Zhttps://www.soliforum.com/post/59103/#p59103<![CDATA[Re: Slic3r supports]]>Look into cura also just for prints that require support.]]>https://www.soliforum.com/user/5588/2014-06-22T03:10:52Zhttps://www.soliforum.com/post/59102/#p59102<![CDATA[Re: Slic3r supports]]>I changed the overhang to 45° and it did everything I needed it to. I'll see if it works on other stuff but this is all I wanted for this print]]>https://www.soliforum.com/user/6031/2014-06-18T00:30:30Zhttps://www.soliforum.com/post/58810/#p58810<![CDATA[Re: Slic3r supports]]>1.0.1]]>https://www.soliforum.com/user/6031/2014-06-17T15:33:31Zhttps://www.soliforum.com/post/58786/#p58786<![CDATA[Re: Slic3r supports]]>What version of Slic3r are you using?]]>https://www.soliforum.com/user/6047/2014-06-17T15:02:11Zhttps://www.soliforum.com/post/58782/#p58782<![CDATA[Slic3r supports]]>Does anyone know how to enable some sort of simpler support system? Sorta like the supports that only go under the major overhangs? I am trying to print a very detailed print, but the gcode generated by slicer covers almost everything with support material? Any suggestions?]]>https://www.soliforum.com/user/6031/2014-06-16T23:55:02Zhttps://www.soliforum.com/post/58760/#p58760