<![CDATA[SoliForum - 3D Printing Community — E3D with Solidoodle 4]]> 2014-06-08T14:45:00Z PunBB https://www.soliforum.com/topic/6674/e3d-with-solidoodle-4/ <![CDATA[Re: E3D with Solidoodle 4]]> It is very possible...

Bookmaker wrote:

Thanks Azerate!  Not bad once you learn how. http://i.imgur.com/5iMzxPI.jpg

Bookmaker wrote:

I bored the .630" hole to .481" deep and then drilled and reamed the hole for the filament all in the same setup so everything would be concentric.  I then put a 8-32 set screw in the side (visible on photo) to hold it in place.     Sorry for the inch references but I am an American and don't do metric very well.

More can be read at http://www.soliforum.com/topic/6355/upg … -question/
It starts off as Lawsy's carriage upgrade, but mutated into pretty much anything else, which includes a discussion on E3D and SD4s.

Hope this helps

]]> https://www.soliforum.com/user/4188/ 2014-06-08T14:45:00Z https://www.soliforum.com/post/58210/#p58210 <![CDATA[E3D with Solidoodle 4]]> Hello Everyone! I can't wait for my E3D to arrive, just to check will the E3D work on the aluminium nozzle mount that comes stock with my Solidoodle 4?

Thanks!

]]> https://www.soliforum.com/user/395/ 2014-06-08T13:49:00Z https://www.soliforum.com/post/58208/#p58208