<![CDATA[SoliForum - 3D Printing Community — ABS & PLA on a E3D]]> 2014-05-24T18:35:21Z PunBB https://www.soliforum.com/topic/6503/abs-pla-on-a-e3d/ <![CDATA[Re: ABS & PLA on a E3D]]> Filament diameter number should come from....measuring your filament.

Extrusion multiplier should come from a single wall calibration. (http://solidoodletips.wordpress.com/201 … flow-rate/)

Both are covered dozens of times on this forum.

]]> https://www.soliforum.com/user/221/ 2014-05-24T18:35:21Z https://www.soliforum.com/post/56931/#p56931 <![CDATA[Re: ABS & PLA on a E3D]]> Ok, now that I know the E3D didn't matter I can try the stock 1.75mm and .8 extrusion as a base.

]]> https://www.soliforum.com/user/1758/ 2014-05-24T18:13:56Z https://www.soliforum.com/post/56930/#p56930 <![CDATA[Re: ABS & PLA on a E3D]]> Suppose so but I can messed with the settings alot to make it work better with the stock hot end. I am sure I can find those settings on this board somewhere if they are the same.

]]> https://www.soliforum.com/user/1758/ 2014-05-24T18:11:38Z https://www.soliforum.com/post/56929/#p56929 <![CDATA[Re: ABS & PLA on a E3D]]> Neither numbers are E3D dependent. Especially not diameter.

]]> https://www.soliforum.com/user/221/ 2014-05-24T18:08:32Z https://www.soliforum.com/post/56928/#p56928 <![CDATA[ABS & PLA on a E3D]]> What filament (diameter and Extrusion multipliers) are people using on an E3D for PLA and ABS?

]]> https://www.soliforum.com/user/1758/ 2014-05-24T17:51:43Z https://www.soliforum.com/post/56927/#p56927