<![CDATA[SoliForum - 3D Printing Community — Bottom of Print Not Flat]]> 2014-05-07T01:04:02Z PunBB https://www.soliforum.com/topic/6366/bottom-of-print-not-flat/ <![CDATA[Re: Bottom of Print Not Flat]]> Of all the nights to not have my PC.  Raise your bed, increase your bed temp to 105 and enclose the printer.  If you don't have glass with hairspray, get some.

]]> https://www.soliforum.com/user/2291/ 2014-05-07T01:04:02Z https://www.soliforum.com/post/55822/#p55822 <![CDATA[Re: Bottom of Print Not Flat]]> Yes. Literally thousands of people have encountered this, it is probably the most common issue in all of 3D printing. Try searching for "curl" or "warp".

]]> https://www.soliforum.com/user/221/ 2014-05-07T01:03:33Z https://www.soliforum.com/post/55821/#p55821 <![CDATA[Bottom of Print Not Flat]]> I started printing a .42 mm calibration cube to set the filament flow, and I noticed that the bottom of the print is curled upwards slightly. This makes it impossible to calibrate the flow rate, so I was wondering if anyone had experienced this before and had a possible solution.

Here is a picture of the finished print, sorry for the poor quality.

]]> https://www.soliforum.com/user/5768/ 2014-05-07T00:59:56Z https://www.soliforum.com/post/55819/#p55819