SoliForum - 3D Printing Community — Problems with circles

Re: Problems with circles

2014-05-06T12:42:07Z

There is the stock fan on my printer (SD2), it seems to be going at all times.

I have no adjusted my cooling print speed, so I can try that.

I'll check out the "how to end circle problems forever" about those Y belts. I also have not tightened the various belts in a long time, and I have been printing a lot.

Thanks for the help.

Re: Problems with circles

2014-05-06T02:43:35Z

accusedmonk wrote:

Do you have a fan on your printer? If not it would help a lot with the small features/layer being printed to fast. Also, under the filament settings, change your cooling print speed to 20mm/s or so
As far as actual calibration, this tutorial should help you out quite a bit:
http://wiki.solidoodle.com/belt-adjustment

+1 I would add that circle problems are mostly caused by misalignment of the side Y-axis belts. Second to that is deflection of the y-axis drive rod. This can be fixed by adding a pillow block with bearings on that drive rod. Search " how to end circle problems forever"

Re: Problems with circles

2014-05-06T01:22:55Z

Do you have a fan on your printer? If not it would help a lot with the small features/layer being printed to fast. Also, under the filament settings, change your cooling print speed to 20mm/s or so

As far as actual calibration, this tutorial should help you out quite a bit:
http://wiki.solidoodle.com/belt-adjustment

Problems with circles

2014-05-06T00:23:46Z

Seems my prints are ok except the worst part being circles and curves. Suggestions, I've tried to calibrate what I can.