<![CDATA[SoliForum - 3D Printing Community — Snowflake Cookie Cutter]]> 2012-12-05T16:55:31Z PunBB https://www.soliforum.com/topic/616/snowflake-cookie-cutter/ <![CDATA[Re: Snowflake Cookie Cutter]]> Ian, any chance we can get your KISS slicer config in a nice downloadable ini?

]]> https://www.soliforum.com/user/35/ 2012-12-05T16:55:31Z https://www.soliforum.com/post/6383/#p6383 <![CDATA[Re: Snowflake Cookie Cutter]]> I designed and printed a snowflake cookie cutter too, but mine doesn't look like yours.  Guess it's true what they say...   Nice job Ian.

]]> https://www.soliforum.com/user/78/ 2012-11-23T20:23:37Z https://www.soliforum.com/post/5475/#p5475 <![CDATA[Re: Snowflake Cookie Cutter]]> Going to print this when I get home.

]]> https://www.soliforum.com/user/2/ 2012-11-23T18:39:54Z https://www.soliforum.com/post/5469/#p5469 <![CDATA[Re: Snowflake Cookie Cutter]]> The base is about 95mm.  It was kapton with a bit of hairspray in a closed case, so it was pretty good.  Also the base is mostly an open ring so there aren't many places where the force from shrinkage can reach all the way across the print.

]]> https://www.soliforum.com/user/14/ 2012-11-23T17:23:15Z https://www.soliforum.com/post/5459/#p5459 <![CDATA[Re: Snowflake Cookie Cutter]]> Very nice Ian! 

I'm surprised the base didn't warp, its quite large and flat. My first guess was you printed in PLA, but then mentioned acetone smoothing so it must be ABS.

]]> https://www.soliforum.com/user/80/ 2012-11-23T17:19:56Z https://www.soliforum.com/post/5458/#p5458 <![CDATA[Snowflake Cookie Cutter]]> http://solidoodletips.files.wordpress.com/2012/11/img_3157.jpg

http://www.thingiverse.com/thing:35442

It didn't slice very well in Slic3r 096, so I recommend Skeinforge or KISSlicer for this one.  Set the extrusion width to .35mm so the wall prints as 2 perimeters.  I recommend acetone smoothing to add strength, especially to keep the edge from splitting.

]]> https://www.soliforum.com/user/14/ 2012-11-23T16:46:13Z https://www.soliforum.com/post/5456/#p5456