<![CDATA[SoliForum - 3D Printing Community — SD3 X-Axis slipping on layers. Please help!]]> 2014-04-13T18:21:58Z PunBB https://www.soliforum.com/topic/6137/sd3-xaxis-slipping-on-layers-please-help/ <![CDATA[Re: SD3 X-Axis slipping on layers. Please help!]]> Also, have you greased the axis rods?

]]> https://www.soliforum.com/user/296/ 2014-04-13T18:21:58Z https://www.soliforum.com/post/54136/#p54136 <![CDATA[Re: SD3 X-Axis slipping on layers. Please help!]]> (1) Do you have a fan on your stepper driver chips?
(2) Do you have a fan on your X-motor? It is not strictly something that should induce step skipping, but it would be wise to cool down your X-motor (they run a bit hot to get more out of them. [Actually as a result, not "to"])

At the end of long prints however suggests to me maybe you're overextruding and accumulating bumps, is your infill very bumpy at the part where it starts skipping?

Also
(3) check the Vref value on your X-driver board. It involves taking a multimeter to GROUND on the driver board, and the red probe onto the potentiometer (little screw driver thing) on the driver chip. This will be easier if you have a red sanguinololu board, and not the printrboard (IDK which you have.)

]]> https://www.soliforum.com/user/192/ 2014-04-13T16:07:09Z https://www.soliforum.com/post/54132/#p54132 <![CDATA[SD3 X-Axis slipping on layers. Please help!]]> My solidoodle 3 keeps slipping on layers only towards the end of long prints. And I mean only 3 hour prints. I need to know how to fix it! I already adjusted the y-axis when I first got it so that no longer has problems so I have no clue how to fix the x-axis. I'm not sure if it's binding, slipping, etc.

]]> https://www.soliforum.com/user/5118/ 2014-04-13T15:08:28Z https://www.soliforum.com/post/54121/#p54121