2014-04-11T04:08:46Z PunBB https://www.soliforum.com/topic/6107/solidoodle-fans/ I've had $2 Chinese-made fans that are better quality than the Soli models... Definitely worth exorcising them from your printer.

]]> https://www.soliforum.com/user/3013/ 2014-04-11T04:08:46Z https://www.soliforum.com/post/53975/#p53975 Yep, lots of folks have had to replace fans. A popular model seems to be the Noctua 40mm fans. They aren't cheap, but they are really really quiet and work very well.

]]> https://www.soliforum.com/user/270/ 2014-04-10T15:46:06Z https://www.soliforum.com/post/53920/#p53920 I do not know if this is 4 specific but I have already found two fan failures. One was on the extruder motor and one in the electronics box. Both became intermittent. I found the issue was were the wires go into the fan motor. I also found the fans are all bushing fans so I decided to replace them all because of a possible lot issue causing more connection failures and switch to ball bearing fans as a couple are already starting to get noisy. I did not request replacements from solidoodle because fans are cheap, I wanted the fast and I wanted better fans. If you want to test yours, just wiggle the wires at the fan base and see if the fan cuts out. Note I said wiggle not jerk. If it cuts out, I would replace it because a fan is cheaper than a motor and a fan. The fan sizes for all 40x40x10. The price difference between bushings and ball bearings are only about a dollar or so.

]]> https://www.soliforum.com/user/4668/ 2014-04-10T15:12:09Z https://www.soliforum.com/post/53908/#p53908