<![CDATA[SoliForum - 3D Printing Community — Sanguinololu Driver?]]> 2014-03-23T14:23:47Z PunBB https://www.soliforum.com/topic/5936/sanguinololu-driver/ <![CDATA[Re: Sanguinololu Driver?]]> ok. Driver was successfully installed, but no lights or fans. Everything else seems in the up and up as I confirmed with some manual commands in RH.
Any ideas?

Edit: Lights and fans are good. I had +/- reversed. *stupid*

]]> https://www.soliforum.com/user/4188/ 2014-03-23T14:23:47Z https://www.soliforum.com/post/52740/#p52740 <![CDATA[Re: Sanguinololu Driver?]]> It's been a while since I used a Sanguino board, but AFAIK the covers everything you need:
http://www.soliwiki.com/Updating_Solidoodle_Firmware

]]> https://www.soliforum.com/user/815/ 2014-03-23T00:49:02Z https://www.soliforum.com/post/52723/#p52723 <![CDATA[Sanguinololu Driver?]]> I have a borrowed Sang and I cannot find the driver on Soliwiki. I am certain since SD switched to the abominable Printrboard, they would no longer have it on their site.

Anyone have the link bookmarked? Please?
Thank you for your help in advance smile

]]> https://www.soliforum.com/user/4188/ 2014-03-22T23:16:40Z https://www.soliforum.com/post/52720/#p52720