SoliForum - 3D Printing Community — Soliwiki Wrong?

Re: Soliwiki Wrong?

2014-03-25T01:18:40Z

You can use either, as long as it is properly setup on your firmware to use that kind of thermistor. I don't know if the one you have stock for your solidoodle has the same resistance correspondence as the one you bought.

For example, when you switch to the E3D it uses a different thermistor type in the firmware, so you have to change that.

Re: Soliwiki Wrong?

2014-03-24T23:10:58Z

Big one is the stock one vs the tiny ones from digikey. so either way i can use both?

Re: Soliwiki Wrong?

2014-03-19T04:35:00Z

I also believe that the blue connector for the thermistor on the e3d wiki is not right, but luckily some normal break-away headers can be used as well and maintain the easy coupling.

Re: Soliwiki Wrong?

2014-03-19T01:14:43Z

Smaller is better for thermistors, as it lowers the time constant.

OP, I'm not sure what you're asking here - as long as the setting in your firmware matches the installed thermistor, you're good to go.

Re: Soliwiki Wrong?

2014-03-19T01:11:49Z

When I got my E3D from Filastruder, I immediately noticed how small the thermistor was in comparison to the stock one. However, It is certainly an upgrade.
I am not an electrical expert, so I cannot give a definitive word of wisdom.
However, some of the best minds on here contribute regularly to Soliwiki.

Is the thermistor you are holding the old or the new?

Soliwiki Wrong?

2014-03-18T21:12:02Z

I feel this is not the correct part for a sd3. was that list for the sd2?

part # 495-2125-nd from digikey