<![CDATA[SoliForum - 3D Printing Community — Backlash]]> 2012-11-18T09:55:33Z PunBB https://www.soliforum.com/topic/573/backlash/ <![CDATA[Re: Backlash]]> ahhh, I gotcha... is that why I have this happening? (see attached pic)

I kinda fixed it by changing the flow-rate higher but the nozzle schmears the filament to fill in the gap and leaves an ugly/rough finish. How can I test to see which motors are the ones with slack? Or can I just tighten the hell out of everything just to make sure?

Where can I find instructions on how to adjust it through the firmware?

Thanks.

]]> https://www.soliforum.com/user/19/ 2012-11-18T09:55:33Z https://www.soliforum.com/post/5083/#p5083 <![CDATA[Re: Backlash]]> In a nutshell its when there is slack in the movement of one or more axis.

Imagine asking for 50mm but only a 48mm movement is made because the first 2mm of energy went into taking up the slack.

To remove, it can be done mechanically with belt tension (x or Y) or a z screw nut (z).

Software can also be used to compensate (lash in Skeinforge or Neil's hysteresis frmware code) where 52mm is asked for to guarantee the desired 50mm is achieved.

]]> https://www.soliforum.com/user/51/ 2012-11-17T12:01:21Z https://www.soliforum.com/post/4973/#p4973 <![CDATA[Backlash]]> So in a bunch of recent threads you guys have been talking about backlash.

What is it, and if its a problem how can I fix it? Are there any links on this? I googled but still dunno what you guys are talking about.

Thanks in advance.

]]> https://www.soliforum.com/user/19/ 2012-11-17T10:17:34Z https://www.soliforum.com/post/4972/#p4972