<![CDATA[SoliForum - 3D Printing Community — Filament Sub Forum]]>2014-03-05T23:40:22ZPunBBhttps://www.soliforum.com/topic/5705/filament-sub-forum/<![CDATA[Re: Filament Sub Forum]]>I sure could use filimental input here! no pun intended,naw it was a shot folks but yes we need people to give views.I use octave 1.75mm 1kg spool and it mic's that is measures actual dia of 1.83 so i use offset in reptier to compensate.I run stock sd2 and hothead is running 195 consistant now troubles there.I had run 200 but it ws a bit hot and 5 deg ooler at 195 works for me. the color is white,I have red green blue but not tested them yet.]]>https://www.soliforum.com/user/3759/2014-03-05T23:40:22Zhttps://www.soliforum.com/post/51508/#p51508<![CDATA[Re: Filament Sub Forum]]>+1]]>https://www.soliforum.com/user/738/2014-03-04T20:39:13Zhttps://www.soliforum.com/post/51433/#p51433<![CDATA[Re: Filament Sub Forum]]>I second (fourth?) this. It'd be a handy place to easily share impressions of the filament we purchase, and let us have more than a single topic on the subject.]]>https://www.soliforum.com/user/4727/2014-02-28T07:34:51Zhttps://www.soliforum.com/post/51094/#p51094<![CDATA[Re: Filament Sub Forum]]>That would be fine with me!]]>https://www.soliforum.com/user/1682/2014-02-27T13:36:30Zhttps://www.soliforum.com/post/51013/#p51013<![CDATA[Re: Filament Sub Forum]]>this is what i wanted with this...kind of
]]>https://www.soliforum.com/user/55/2014-02-26T21:51:14Zhttps://www.soliforum.com/post/50933/#p50933<![CDATA[Filament Sub Forum]]>There are enough types of ABS, PLA, Nylon,Tglase/PETT, Rubbery, Support filaments out there I think it would be beneficial to have a sub forum for it all.
I always see them scattered all over but never in one place.